Tag Archives: dino

It’s not just me!

Posted on by

See!  Spacexula has discovered the hard way she’s a wicked temperamental woman!

Shattered acrylic plastruder…  Yikes!  I printed up one of Zaggo’s Prinstruders – but it appears to be optimized for an early MakerBot Batch 5 with large/small dinos.  If I wanted to use my printstruder I would need to pick up some of the extra parts required and essentially print up a small dino.1  However, I think I’d like to start replacing parts out of my MakerBot with printed parts so that I can keep the originals as backups.  However, I have a feeling a prinstruder out of ABS is going to be much more robust/resilient than the layered acrylic plastruder.  What do I need?

  • 2x 626 ball bearings.
  • 4x M4 bolts, 60mm long
  • 4x M4 nuts (optionally two of them as wingnuts)
  • 1x M6 bolt (30mm long)
  • 1x M6 nut
  • 3x M3 bolts (30mm long)
  • 3x+ M6 washers
  • 3x+M3 washers
  • 4x M4 washers

In addition to these parts, I’ll also need to measure my ‘bot for a small dino equivalent.  Since my extruder barrel is out of commission and the plastruder is just lying on the platform, this is as good a time as any to measure it up.

  1. Shopping list below [↩]

Stopping for now

Posted on by

The body of the MakerBot is complete, rods in, X and Y stages in, pulleys and belts on, motors bolted on.  No opto-ends stops yet for obvious reasons.  The opto-endstops also require popsicle sticks.

On to the plastruder.  I put together the Weird Dino and the Tall Dino, but the idler pulley requires super glue.  I don’t happen to have any lying around, so I’ll need to go out to the hardware store.  But, this is as good a spot to stop as any.

I originally intended to document each step – but the directions on the MakerBot wiki are so good that there’s just no need.  So, the pictures you’re going to see are going to basically jump from a bunch of spraypainted wood giant chunks of the robot already bolted together.

The build process, much of what consists of fitting pieces together and using the MakerBot “t-slot” semi-captive nut method, is very intuitive, relatively easy, and extremely gratifying.  Sometimes its a little bit of effort to get that nut in the notch properly, but it was never that bad.