Don’t leave your extruder on and not running too long. It will drip, then the PLA will turn amber, and then it will clog.
That’s all I’ve learned about PLA first hand.
Oh, well, that and it’s a royal pain in the ass.
Don’t leave your extruder on and not running too long. It will drip, then the PLA will turn amber, and then it will clog.
That’s all I’ve learned about PLA first hand.
Oh, well, that and it’s a royal pain in the ass.
It didn’t actually look burned. Is “burned PLA” the amber stuff I found dripping from my extruder barrel after I left plastic sitting warm too long?
Is this a symptom of sitting warm too long or too much heat, both, neither, something else?