ProfileMaker: More than 209 profiles and 58 people served!

More than 58 people have generated profiles with ProfileMaker1 !

Seriously, you need to stop printing calibration cubes and fiddling with Skeinforge.  Find out more than 58 people have discovered and start using ProfileMaker to create your Skeinforge profiles.  You can either manually enter the values provided by ProfileMaker into Skeinforge or have it e-mail you a ready-to-slice Skeinforge profile.

Always wanted to try printing at 0.25mm per layer or with 1.75mm filament or in PLA?  Your ‘bot can do it.

  1. Powered by SCIENCE! []

4 thoughts on “ProfileMaker: More than 209 profiles and 58 people served!

  1. Did some one try the profilmaker with a Mendel/Wades Extruder?
    What do you put into the gear diameter field? it seems to me that the fact that wades extruder uses 2 gears to drive the hobbed bolt instead of an direct drive should be handled differentyl, shouldn’t it?

    Regards
    Sven

  2. @Sven: I honestly don’t know if anyone has tried ProfileMaker with a Mendel or Wade’s extruder. You make an excellent point about the gear’s diameter in this case. I think if I were you I’d try the gear diameter of the actual hobbed bolt.

  3. Pingback: Two weeks later | MakerBlock

Comments are closed.