While looking at the Adafruit Drawdio v1.1 I noticed that it runs off of a single AAA battery. That’s certainly small enough to fit into a printed sonic screwdriver!
And, of course, it would make for an actually sonic sonic screwdriver…
While looking at the Adafruit Drawdio v1.1 I noticed that it runs off of a single AAA battery. That’s certainly small enough to fit into a printed sonic screwdriver!
And, of course, it would make for an actually sonic sonic screwdriver…
I just redesigned the printable screwdriver in order to make the parts fit together better and be more printable.
It should be easier to see how these parts go together.
Basically, you take the “mid-handle” at the far end of the build sheet, turn it upside right, clamp the two “lower handle” pieces on either side of it, and slide that bottom ring onto the lower handle.
I still need to redesign the upper handle, hollow out the mid-handle, and make sure there’s enough room inside for the GoodFET / electronic sonic screwdriver guts.
Now I’m wondering if it is also possible to make this a piece of MakerBot origami – and make it printable on one build sheet…