Skeinforge settings changes

Posted on by

I figured, why not treat this blog as my lab book, right?  It’s a good way to document changes in settings, as well as my rationale for doing so.  Thusly, and without further ceremony, delay, pomp, or ado, I present for your kind consideration and review my latest Skeinforge changes:

  1. Skeinforge->Raft->Activate Raft: checked->unchecked
    • Now that I’m printing in PLA, I won’t need the raft.  As you can probably tell from the pictures below I’ve covered my acrylic build base in blue painter’s tape.  I think I’ll probably just take one of my spare foamcore build surfaces and cover that with blue tape and give that a shot.  I’ve noticed that as soon as my extruder heats up the PLA starts to ooze out.  This isn’t a problem as far as I can tell.  However, it does let some PLA drip – but when I start to run the extruder again it doesn’t extrude at all.  My guess is that the oozing PLA is dripping out of the nozzle, which then has to be filled back up to extrude.  ANYhow, my point is that if I heat up the extruder and don’t immediately start to print it will take a while to fill the nozzle, which means the raft gives the extruder sufficient time to get going before the part is being printed.  Rather than print a raft, waste the plastic, and then have to chip it off later it makes more sense to make sure I advance the extruder a little before I start printing.
  2. Skeinforge->Fill->Infill Solidity (ratio): 0.4->0.3
    • I’ve printed with as little as a 20% fill with no noticeable problems.  I suppose it would really depend on your model.  If the top of the model begins to taper up to a point, then you could probably print with 0% fill.  However, if the top of your build is flat, the topmost layers won’t have much to rest on and will sag just a little.  This doesn’t appear to be a structural problem, but more of an aesthetic one.
  3. Skeinforge->Fill->Infill Begin Rotation (degrees): 45.0->90.0
    • I tried reprinting Zaggo’s whistle in PLA and it didn’t come out – just like it didn’t come out in ABS.  I’m not sure how or why, but my infill rotation got set to 45.  I figure I might have a more solid fill/wall if I had this rotate to 90 degrees.  We’ll find out!
  4. Skeinforge->Fill->Solid Surface Thickness (layers): 3->4
    • This was just a slight tweak to see if I could make solid layers slightly more solid and waterproof/airtight.