Sometimes after I finish a print I know I’m going to print something else in a few minutes. In those cases I want to keep the heater warm rather than waiting to cool it down, warm it back up, and then start printing. Here’s my new idea – I use the in between print time to print something quick, simple, useful, and relatively worry-free.
Insulator retainer rings. I’m guessing you just can’t have too many of these. As suggested by Cathal Garvey, this should be a high priority print.
You could just leave the heater on between prints :)
I *could* do that… but it’s also easy enough to crank out these little parts while I fiddling with a model.
Plus, the last time I just left the heater on between prints the thermistor flashed/sparked and stopped working. :/
I figure productivity is the better part of cowardice. ;)